Which two options can be used to identify a damaged or failing flash card on an X9M-2 Database Machine High Capacity storage server?

• A. hardware monitoring using the storage server ILOM
• B. using the CELLCLI CALIBRATE command on the storage server after logging in as the celladmin user
• C. using the CELLCLI list LUN DETAIL command as the celladmin user
• D. using the CELLCLI CALIBRATE command on the storage server after logging in as the root user

You have been asked to design a backup solution for an Exadata X9M-2 Quarter Rack with Extreme Flash Storage Servers connected to a new ZFS Storage Appliance ZS7 with 2 Storage Controllers with 100Gb Ethernet cards and 3 Storage Trays. You are using Oracle Exadata Configuration Assistant to validate the rack layout.
1. Use "Add Equipment" to add the Exadata X9M EF Storage Servers, starting from RU10.
2. Use drop down to add ZFS Storage Appliance Controllers.
3. You cannot add ZFS Storage Appliance to an Exadata Rack.
4. Use "Add Equipment" to add the ZFS Storage Trays, starting from RU1.
5. Use drop down to add ZFS Storage Trays.
6. Use "Add Equipment" to add the Exadata X9M Database Servers, starting from RU16.
7. Use "Add Equipment" to add the Exadata X9M EF Storage Servers, starting from RU1.
8. Use drop down to add Exadata X9M EF Storage Servers.
9. Use "Add Equipment" to add the ZFS Storage Controllers, starting from RU27.
10. Use drop down to add Exadata X9M Database Servers.
11. Use "Add Equipment" to add the ZFS Storage Trays, starting from RU31.
Which of these steps are correct and what is their correct order?

• A. 10, 8, 2, 5
• B. 7,6,9,11
• C. 4,1, 6, 9
• D. 3
• E. 10, 8, 9, 11

You plan to monitor the status of the motherboard, memory, power, fans, and network cards on the database nodes in your Exadata Database Machine using Enterprise Manager.
Where must you set the thresholds for these hardware components and why, to assure that sensor readings, faults, and any related alerts, are visible in Enterprise Manager?

• A. No thresholds need to be set because they are preset in the ILOM and in Enterprise Manager
• B. Set thresholds in ILOM and in Enterprise Manager because they are not preset anywhere and must be set in both places.
• C. No thresholds need to be set because they are preset in the ILOM and these are sufficient for monitoring.
• D. Set thresholds only in ILOM because they are not preset anywhere but need to be set only in ILOM.

Your customer would like to configure monitoring capabilities Auto Service Request (ASR) on the stand-alone server that was set aside to run ASR Manager.
What configuration should you set up for the customer?

• A. Enterprise Manager, Exachk and ASR Manager on the stand-alone server because ASR needs Exachk for continuous Hardware monitoring.
• B. Enterprise Manager and ASR Manager on the stand-alone server because ASR is not a monitoring tool.
• C. ASR Manager inside the firewall along with ExaWatcher to monitor Database and Storage Server performance.
• D. ASR Manager with SNMP traps configured to listen for specific alerts triggered by Exadata Intergrated Lights Out Manager (ILOM).

Which three component faults are covered by Oracle Auto Service Request (ASR)?

• A. Proactive recommendations for firmware
• B. System Controller (SC)
• C. I/O boards
• D. RoCE network interface cards
• E. Fan trays
• F. File system unmounted